Model
Specification |
D-60A |
D-60B |
CH1 |
CH2 |
CH1 |
CH2 |
| DC output voltage |
5V |
12V |
5V |
24V |
| Output voltage error（Note：2） |
±2% |
±6% |
±2% |
±5% |
| Rated output current |
4A |
3A |
3A |
1.8A |
| Output current rage |
0.3-6A |
0.2-4A |
0.3-6A |
0.2-2.2A |
| Wave and noise(Note ：3） |
75mVp-p |
150mVp-p |
75mVp-p |
150mVp-p |
| Inlet stability(Note ：4） |
±0.5% |
±1% |
±0.5% |
±0.5% |
| Load stablity (Note ：5） |
±0.5% |
±4% |
±0.5% |
±4% |
| DC output power |
56W |
58W |
| Efficiency |
73% |
73% |
| Adjustable range for DC voltage |
CH1;+10,-5% |
CH1:+10,-5% |
| AC input voltage range |
85-132VAC/170-264VACSelected by
switch47-63Hz,120-370VDC |
| Input current |
2A/115V 1A/230A |
| AC INnrush current |
Cold-start current30A/115V 60A/230V |
| Leakage current |
<1mA/240VAC |
| Overload proctection |
105%-150%Type:Foldback:current limiting reset:auto
recovery |
| Over-voltage protection |
CH1：5.75~6.75V |
| High-temperature protection |
………… |
| Temperature coefficient |
±0.03%/℃（0-50℃）ON+5V |
| Setup rise hold up time |
800ms,50ms,30ms/115AC 300ms,50ms,80ms/230AC |
| Vibration |
10-500Hz,2G 10min,/1cycle，Period for60min，Each axes |
| Withstand voltage |
Input and output internal：1.5KVAC,Input and
enclosure：1.5KVAC,Output and enclosure：0.5KVAC |
| Isolation resistance |
Input and output internal:Input and enclosure,Output
and enclosure：500VDC/100MΩ |
| Working temperature and humidity |
-10℃~+60℃（Refer to output derating
curve），20%~90%RH |
| Store temperature and humidity |
-20℃~+85℃。10%~95%RH |
| Overall dimension |
159×97×38mm |
| Weight |
0.55Kgs |
| Safety standards |
UL 1012 TUV EN60950(IEC950,UL1950)Approved |
| EMC standards |
CISPR22（EN55022）class B，IEC801-2，3，4，IEC555-2
Approved |
Note：
1.The testing condition for the paramenter
above is :230VAC input,rated load,25℃70%
RH.Humidity.
2.Error.include the setting error,line stability and
load stability.(Note:5).
3.Wave test:adopting "A12"double wire
for 20MHz,and 0.1UF&47UF capacitor short-circuit for
interrupting.
4.Inlet voltage stability test:when is over
load,the lowest voltage of inlet is up to the highest
voltage.
5.Load stability test:the load is from 0% to 100%.
6.Total output canbe maximum Current,total load can not exceed
the maximum output power
7、C2、3、6 must be knocked
down. |
